These instructions are for the preparation and installation of of the walkways on the tallow tanks. Also they cover positioning of decals. Only superglue is used on this model.
Firstly fold the legs of the etch under the walkway section so only a short length in clear of the walkway section. Glue keeping even distances between each leg.
Below is a link for templates to aid positioning of the walkways to the tanks. The choice of the two relates to the height required. Decide which is to be used and laminate the template to a thin piece of plastic. Sore along the line displayed so help following the contour of the tank. Drill where displayed used a 0.50 mm drill.
Test positioning with the etch and when satisfied glue.
Below is a lick to a diagram to aid positioning of decals.